• 济南慧杭门业有限责任公司
  • 联系人:张经理
  • 手机:15966334566
  • 地址:济南市工业南路106号
  • 网址:http://www.jnjqjc.com
新闻中心当前位置:首页-新闻中心
    讲解安装电动卷帘门的方法步骤
    来源:http://www.jnjqjc.com   时间:2015-12-15 11:53:18
    讲解安装电动卷帘门的方法步骤:
    Interpretation of the electric shutter installation steps:
    、先在需要安装的门框框口位置画出线。表明尺寸大小,然后找工作人员设计出合适的电动卷帘门,这里值得注意的一点是框内高度比门扇的高度要高一点点。
    First, the first in a door frame mouth position needs to be installed. Show that the size, and then find a job researchers designed a suitable electric rolling door, it is important to note here is the box height a little bit higher than the height of the door leaf.
    第二、先把电动卷帘门的门框固定,这里要先拆掉门框下部的固定板。(注意:洞口两侧地面要预留凹槽,经校正合格后,固定木楔,门框铁脚与预埋铁板件焊牢。用水泥砂浆或强度不低于10MPa 细石混凝土嵌塞牢固即可。)
    Second, the electric shutter door frame first fixed, here need to pull down a fixed plate at the bottom of the door frame. (note: the hole on both sides of the ground to the reserved grooves, after calibration qualified, fixed chock, door frame with embedded iron plate welded iron feet. With cement mortar or strength of not less than 10 mpa fine stone concrete plug firmly embedded.)
    第三、安装电动卷帘门扇主体门扇。一定要保证电动卷帘门与墙体结成整体,封闭性要做好,再粉刷洞口及墙体。粉刷完毕后,门缝应均匀平整,开启电动卷帘门应该自由轻便,不得有过紧、过松和反弹现象。

    Third, installing electric shutter door main door leaf. Make sure electric shutter and the wall form a whole, should be sealed and the hole then paint and wall. Painting has been completed, the crack of the door should be uniform flat, open electric doors should be free of portable, can not have too tight, too loose and rebound phenomenon.