• 济南慧杭门业有限责任公司
  • 联系人:张经理
  • 手机:15966334566
  • 地址:济南市工业南路106号
  • 网址:http://www.jnjqjc.com
新闻中心当前位置:首页-新闻中心
    济南玻璃门拉手的安装工作
    来源:http://www.jnjqjc.com   时间:2016-4-28 11:37:23

    济南玻璃门拉手的安装工作
    Jinan glass door shake handshandle installation work
    首先把玻璃门平放,在预先要安装拉手的地方做好记号,用电转装上对应规格的金刚砖头兑水打眼;

    First turn on the glass door flat, mark where prior to installation shake handshandle, turn on electricity corresponding specifications kong punchs a hole brick water;
    此时得注意防护,以免玻璃破裂。如果不是钢化玻璃的话,就用10mm的玻璃钻头,量出拉手的孔距中心到中心,在玻璃上标记好,浇水打孔。
    At this time must pay attention to protection, to avoid glass broken. If not toughened glass, glass drill with 10 mm, measure the shake handshandle of hole is apart from the center to center, mark on the glass, watering holes.
    接着在拉手插入玻璃的部分涂少许玻璃胶。拉手组装时,其根部与玻璃靠紧密后再按紧固定螺钉,以保证拉手没有松动现象。
    Then handle insert part of the glass with a little glass glue. Handle assembly, its roots and glass by close again after press tight set screw, in order to keep the handle without loose phenomenon.
    后安装拉手时先从外面上,在里面拧拉手的长螺丝,别把拉手的螺丝留外面了,那样能够从外面把拉手卸掉的。
    Finally to start for the installation of shake handshandle on from the outside, inside screw handle long screw, don't leave the shake handshandle of screw outside, so can the shake handshandle of removing from the outside.