• 济南慧杭门业有限责任公司
  • 联系人:张经理
  • 手机:15966334566
  • 地址:济南市工业南路106号
  • 网址:http://www.jnjqjc.com
新闻中心当前位置:首页-新闻中心
    济南玻璃门换玻璃门地弹簧的方法
    来源:http://www.jnjqjc.com   时间:2016-11-9 9:59:42
    济南玻璃门的优点就是干净整洁,这一点是人们普遍喜欢的,也正是因为这个,所以越来越多的场所使用玻璃门。而对于玻璃门的开门来说,关键的零件就是地弹簧了。下面小编为您讲解一下玻璃门换玻璃门地弹簧的方法。
    The advantage of the glass door is clean and tidy, this is the people generally like, it is because of this, so more and more places to use the glass door. And for the door of the glass door, the most critical part is the spring. Below small make up for you to explain the glass door for the door of the spring method.
    1、首先要将玻璃门上夹芯板用螺丝卸下来,再抬起玻璃门。用螺丝将地弹簧的上四个螺丝钉卸掉,然后将地弹簧取出。再将玻璃门地弹簧出现的偏差值记录下来,并在需要更换新的地弹簧处做好标准位置十字线的标记。
    1, the first glass door on the sandwich plate with screws to remove, and then lift the glass door. Remove the top four screws of the ground spring with a screw and remove the ground spring. The deviation value of the spring of the glass door is recorded, and the mark of the standard position cross line is made at the need to replace the new ground spring.
    2、然后凿除已损坏的地弹簧及四周槽坑,清理余灰后立即用湿布擦拭干净。再用刷子蕉水涂刷槽坑四周,使之湿润后在刷一遍素水泥浆或界面剂。
    2 then, chiseling damaged springs and around the pits, clean up the ashes after immediately wipe clean with a damp cloth. Then brush banana water brushing groove around the wet brush again in cement paste or interface agent.
    3、将新的地弹簧按照标注的十字线位置安放到位,四周用小木楔子加以固定,高低位置垫衬采用不同呢规格的段钢筋头垫底。
    3, the new spring in the cross line position marked in place, with a wooden spatula to be fixed around, height of lining steel head bottom with different specifications.
    4、按需要量搅拌好1:15的水泥,粗砂“干硬性水泥砂浆”,干硬程度以用手捏能感到潮湿为准,太湿了不能起到即时固定地弹簧的作用,然后往槽坑内分层填充,随填随用榔头及钢錾敲击密实,真个操作过程中应分层次检查地弹簧的位置是否准确,如有移位现象随时调整。
    4, according to the requirement of mixing 1:15 cement, coarse sand "dry cement mortar", by hand can feel wet as dry, too wet can not play the role of the spring fixed instant, and then into the slot. The layered filling with filling with hammer and chisel steel tapping dense. Different levels checked the accuracy of the location is really a spring in the process of operation, such as a shift at any time.
    5、待填充到与地平面持平时,后一遍榔头锤平后再用铁抹子稍加水抹平即可成活。如有地面砖面层的,只要在糙面层上浇一层稀薄水泥浆,即可镶贴地面砖面层。
    5, to be filled with the ground surface in the last time, and then a hammer hammering iron float a little water to survive over. If the tile surface, as long as the rough surface layer pouring a thin layer of cement slurry can be inlaid with tile surface.
    6、完工前检查前后、左右、高低偏差等均无差错后,在上面覆盖一层塑料布用以保存水分不流失即可。
    6, before and after the completion of the inspection, the left and right, high and low deviation, and so on, after the above cover a layer of plastic cloth to keep the water can not be lost.
    7、后是要安装新的地弹簧,与安装的方法一样。如果自己不能完成的话,就只能请人来帮忙了。
    7, the last is to install a new ground springs, the same as the method of installation. If you can't finish it, you'll have to ask someone to help.
    对于更换玻璃门地弹簧的步骤就是这些,如果我们能够正确的安装的话,可以很好的使用,如果出现偏差,这对玻璃门的开关有很大的影响。以上就是小编为大家带来的,希望可以帮助到大家。
    For the replacement of the glass door to the spring of the step is these, if we can properly install the words, can be very good use, if the deviation, which has a great impact on the glass door switch. The above is small make up for everybody brings, hope can help to everyone.