• 济南慧杭门业有限责任公司
  • 联系人:张经理
  • 手机:15966334566
  • 地址:济南市工业南路106号
  • 网址:http://www.jnjqjc.com
新闻中心当前位置:首页-新闻中心
    济南卷帘门电机修护常识
    来源:http://www.jnjqjc.com   时间:2014-11-3 14:11:22

    1、制动器。如果当做工作制动器使用时,要每隔3000个工作时进行检查一次,主要需检查快速门制动器的摩擦片厚度,测量和调整工作气隙、压板、花键套、啮合度、止推环等零部件的工作情况;如果是当作停机制动器使用时,要视负荷的实际状况而定,每隔2-4年进行检查一次,主要需要清除磨损粉尘,检查开关的触点是否需要更换。
    1, brake. If you use as the brakes, check once every 3000 hours, friction plate thickness is mainly to check the

    rapid door brake, measure and adjust the working air gap, a pressing plate, a spline sleeve, engagement, thrust ring

    and other parts of the work; if it is as stopping brake use, to the actual as the load condition and decide, every

    2-4 years inspection time, the main need to clear the wear dust, whether the contact check switch needs to be

    replaced/
    2、电机。需要每隔10000个工作时进行检查一次,主要检查一下球轴承是否需要更换,将轴密封圈进行更换,清理扇热空气通道等。
    2, motor. Every 10000 hours to check again, mainly to check whether a ball bearing needs to be replaced, the shaft

    sealing ring for replacement, cleaning fan heat air channel.
    3、配有逆止器的电机。需要每隔10000个工作时进行检查一次,当逆止器的润滑程度不够时,需要更换低粘度的润滑脂。
    3, motor with non-return device. Every 10000 hours to check once, when not enough lubrication degree backstop, the

    need to replace the low viscosity lubricating grease.
    4、驱动装置。这就需要根据快速卷帘门电机驱动装置实际使用的外部因素来决定检查的周期了,主要是对表面涂层进行修补以及防锈处理。
    4, the driving device. This requires periodic check according to external factors to decide the rapid rolling door

    motor driving device of practical use, mainly is carries on the repair and anti rust treatment on surface coating.
    济南卷帘门http://www.jnjqjc.com