• 济南慧杭门业有限责任公司
  • 联系人:张经理
  • 手机:15966334566
  • 地址:济南市工业南路106号
  • 网址:http://www.jnjqjc.com
新闻中心当前位置:首页-新闻中心
    电动卷帘门保养知识
    来源:http://www.jnjqjc.com   时间:2014-12-17 15:13:57

    1、所有电动控制的卷帘门,启闭运行方向必须与开关箱指示相同,特别是在新接通电源试车或外来输入电源变换相线时,应先使用手动装置将门帘置于门洞高度1/2 的位置,接通电源后试操作卷门启闭,直到与指示相附,方可正常使用,否则损坏限位器,引起卷帘反卷或冲顶等而造成损失。
    1, all electric control shutter doors, opening and closing operation direction and switch box instructions must bethe same, especially in the new power supply is switched on to test or foreign input power transformation phase,should be first placed in the door curtain 1/2 height position using a manual device, the power supply is switchedon after the test open close operation rolling door, until and instructions attached, can be normal use, orotherwise damaged restrictor, caused by anti roll or top shutter caused loss.
    2、卷帘门安装位置的上端应有可靠的防火设施,在卷帘门的卷筒下端做包箱或吊顶时必须设置可拆式活动盖板,在电动卷门机一侧下端必须预留500×500mm可拆检修孔,以便于维修保养。
    The installation position of the upper end of 2, rolling door should be a reliable fire facilities, do must set thedetachable movable cover box ceiling or on the drum at the lower end of the rolling shutter door, electric doorrolling machine in the lower end on one side must be reserved 500 x 500mm detachable inspection hole, to facilitatethe repair and maintenance.
    3、电动卷帘门在启闭停止过程中,应具备随位停止之功能,不应有停止而继续下滑现象,如发生下滑距离大于50mm的情况出现,应立即对卷帘门控制电器和卷门机制动器进行仔细检查修理,运行正常为止。
    3, the electric rolling shutter door opening and closing stop in the process, should have with the stop function,don't have to stop and continue to decline phenomenon, such as the occurrence of glide distance is greater than the50mm of the situation, should immediately to the rolling shutter door control appliances and roll door machine brakecarefully check repair, so far the normal operation.
    4、在电动卷帘门的使用过程中,应该保持器控制和电压稳定,禁止潮湿摔坏等,不可私自打开遥控器。如若发现门体上有电线缠绕、打结等应及时处理。注意通道的是否堵塞,阻碍门体下降,如若发生异响应立即停止电机运作。
    4, in the process of using the electric rolling shutter door, should keep control and voltage stability, banned dampbroke, can not open the remote control. If found on the door wire winding and knotting should be timely treatment.Note that the channel is blocked, impeding the door down, if has the abnormal response to immediately stop theoperation of the motor.
    5、制定保养计划,及时清理电动卷帘门的轨道,保持内部清洁,保持轨道运行畅通。卷帘门电机和传动链条要经常加注润滑剂,检查控制箱内器件和开关控制盒,紧固接线端口,紧固螺丝等,清洁控制箱内、表面和按钮上的灰尘污物,防止按钮卡住而不能反弹。
    5, make the maintenance plan, timely cleaning electric rolling door track, keep clean inside, keep smooth orbit.Rolling door motor and a transmission chain often filling the lubricant, check box control device and a switchcontrol box, the fastening connection port, a fastening screw, clean the dust control box, surface and buttons onthe dirt, prevent the button stuck and can't bounce.
    6、注意经常检查电动卷帘上下行程开关,对行程控制器加润滑油,另外,操作人员手动控卷帘门,检查器运行情况,校对上下行程开关位置,使电动卷帘门开启或关闭时处于适当位置,且检查过程中严防电动卷帘门冲顶或冲底或者反转,如若出现紧急情况应立即停止转动,切断电源。
    6, pay attention to always check the electric rolling up and down stroke switch, the stroke controller to addlubricating oil, in addition, the operator manual control shutter doors, checker operation, proofreading the switchposition, make the electric rolling shutter door is opened or closed in place, and in the process of inspection toprevent the electric rolling shutter door top or punch the bottom or the reverse, if there is an emergency situationshould immediately stop the rotation, cut off the power supply.
    济南卷帘门http://www.jnjqjc.com